Sawdust Pellet Production Plant 4TPH in Morocco

• Raw materials: the local wood blocks, wood shavings and sawdust in Morocco.
• Device layout: three 508 type pellet mill.
• Production: 3.6-4.5TPH.

Technological process of the sawdust pellet production plant:

The raw materials like wood blocks is chipped by the chipper, then go into the wet material hopper. After being ground by the crusher, the materials will go into the drying machine. The wet wood shavings will go through the belt and screening machine, then go into the drying machine, too. After that, all the materials will go into the dry material hopper. The dry materials will be sent into the screening machine by the belt then into the pellet mill by elevator. Some dry wood shavings and sawdust will go into the pellet mill directly after going through the belt, screening machine and elevator. The pellet out of the pellet mill will be carried to the cooling machine by the belt then put into the finished product hopper. The final step is to pack pellets by T bags or small bags.

The highlights of the sawdust pellet production plant:

• This production line uses dry material hopper which is used to store the dry materials from the drying machine. That can provide enough raw materials for the following steps and that can finish the whole production of the sawdust pellet production plant by fewer man power.
• Compared with the single cylinder drum dryer, the drum dryer with three cylinders requires small volume at the same yield. And the heat is enough which greatly meet the customers’ requirement.