HOME > news

Professional Biomass Briquette Charcoal Making Machine for Sale

Why Use Biomass Briquette Charcoal Making Machine?

Fundamentally speaking, the processing of briquette charcoal making machine belongs to the green industry. It produce the waste materials and residues into the green biomass briquettes, to meet the new development. There comes a question: how to make the briquette charcoal making production greener? You should pay more attention to the production processing of biomass briquette charcoal making machine, to make sure that the machinery keeps highest environmental protection property, therefore, the machinery will become greener and greener.
biomass briquette charcoal making machine
How to make charcoa briquettes?

How to Produce Briquette with High Efficiency?

The charcoal output rate of biomass briquette charcoal making machine shows certain of difference due to the different raw material types. the relatively lower carbonization temperature obtain high charcoal output rate, but the finished charcoal briquette has low quality and high corrosive, involved with acid tar substance, thus is not able to be burned as clean smokeless fuel.
How to Produce Briquette with High Efficiency?
charcoal industry analysis>>
The solid carbon content of high quality commercial briquette charcoal should higher than 80%, which requiring the carbonization temperature should be kept over 500℃, the xylogen inside of the raw materials has a positive effect on the charcoal yield. The biomass briquette charcoal production prefers the solid-structure raw materials, thus causing high fragility. In the actual production, it is showed that when the carbonization temperature is in between 550℃-650℃, the fragility and the solid carbon content of the briquette charcoal can be reach to an ideal balance.

When Does the Biomass Briquette Charcoal Making Machine Need Overhaul?

  1. During the briquette charcoal production, how to overhaul if there is smoking? When this situation happens, the machine should be stopped to check if the raw material has high moisture content. If the raw material moisture content is too high, it should be adjusted into 8%-12%; if the moisture content is not the problem, the propeller section has abrasion which is easy to cause smoking; if the propeller is abraded, it should be repaired.
  2. During the briquette charcoal production, the briquette is not easy to be formed. When this phenomenon occurs, the heating ring of the biomass briquette making machine should be checked for if it works or not. If it can not heat, you should replace it with a new one to finish the production.
  3. When the machine stops suddenly during the production, how to repair? When this situation happens, you should check the wire circuit id wrong. If the circuit is wrong, it should be repaired immediately.

Core Principle of The Biomass Briquette Charcoal Making Machine

Whatever the biomass briquette charcoal machine type is, the working principle of propeller is the same the friction produced when the top part touches to the raw materials in the high-speed running causes the section abrasion.
Core Principle of The Biomass Briquette Charcoal Making Machine
When the section angle becomes smaller or the touching part becomes crude with spots in it, the briquettes produced by the biomass briquette making machine does not meet the requirements, even the briquettes may not be discharged. When the propeller of the machine is abraded seriously, the produced briquette density is low. If you want to repair the machine in this situation, the wear resisting electrode can not be used for welding immediately, instead of using the common electrode to weld the initial electrode and smooth it, then the wear resisting electrode can be used for welding.
Top