Feature of Wood Pellet Machine ZLSP-D series| ABC Machinery

Wide range of disposal raw materials

• It has a wide range of processing, wood pellet machine can make pellets from biomass waste that we can find, like weed tree, pine, bamboo wastes, peanut shells, rice husk, wheat straw, etc.
• The largest length of raw material: Make sure the maximum length of raw material is no more than die hole diameter. For example, with 6mm wood pellet machine flat die, the length of wood chips should not exceed 6mm.
• Raw material moisture: Ensure that biomass raw material moisture control between 10% and 18%, different raw material requirements of the moisture is different also, For example, the raw materials that contain lignin or sugar higher in pine wood require a low level of moisture, whereas, they require a high water level.

 

Making High quality pellets

• The density of process pellet is 1.1*10³kg/m³.
• Die orifice compression ratio: Flat die wood pellet machine ZLSP-D orifice compression ratio, different raw materials, due to different packing density, have different quality of lignin. Therefore, it is necessary to have the different form of die hole to achieve the best shaping effect. Our ZLSP-D series wood pellet machine is equipped with a flat model that is processed by a large amount of experimental data from different raw materials, which is best for the general raw materials. However, if the pellets produced by the customer have more dust and less formation rate, we will adjust the flat die compression ratio according to the material.

 

Parameter of ZLSP-D wood pellet machine

	Model	Power(kw)	Output(kg/h)	Weight(kg)	Packing Size(mm)
	ZLSP-D 150B	3phase 5.5	50-100	95/110	800*450*700
	ZLSP-D 200B	3phase 7.5	80-120	200/230	1050*480*930
	ZLSP-D 230B	3phase 11	120-200	290/320	1180*540*1000
	ZLSP-D 260B	3phase 15	160-250	320/360	1240*540*950
	ZLSP-D 300B	3phase 22	250-400	350/380	1300*560*1100

 
 

Structure of wood pellet machine

• Using bevel gear transmission structure: Low cost, Easy to maintenance.
• The wood pellet machine die and the main shaft use 40Cr: High Cr content, more wear-resisting, good quality adjustment steel, good mechanical properties, widely used for important and overloaded occasions, such as crank, wanxiang, main shaft, etc. With special heat treatment technology, the hardness can reach 60HRc, greatly improves the wearability, and the core strength is high, the overall strength is good.

 
ABC Machinery wood pellet machine ZLSP-D series is more suitable for processing cork wood, or making feed pellets. The wood pellet machine ZLSP-D series relative to ZLSP-R series small yield, low prices, small investment costs, more suitable for home or small farm use.
 
The technical R&D center of ABC Machinery focus on the development direction of the biomass energy industry. Through constantly research, improvement, learning and experiment to make sure that our company products are always at the forefront of the biomass energy machinery industry.